Skip to content

SenSafe® John's Copper (Pocket-Pack)

SKU 481142

Check your Copper with Confidence using our SenSafe® John's Copper Check. Featuring our patented Aperture Technology, make sure your Copper levels are where you want them to be. Contains 30 individually wrapped tests in our new environmentally friendly Pocket-Pack!

- Safe and non Hazardous
- Low detection levels
- No interference from Iron.

This water quality test promises to be an attractive alternative to wet chemical copper tests for several reasons: There are no hazardous chemicals to mix (an MSDS is not required); Quick results are obtained in less than 1 minute; No identified interferences; And, best of all, the Copper water quality test strips are safe and easy to use for fast accurate results within the ranges of 0 to 2 ppm (mg/L), which permits the measurement of typical copper levels found in well, tap, and stream water. The test is very convenient to run: dip test strip into sample for 30 seconds with constant back and forth motion, remove, and match color after 2 minutes to quantify the Copper level in the sample. 

Range: 0, 0.05, 0.1, 0.2, 0.4, 1, 2 ppm

Made in USA

Why test for Copper?

This test detects Copper (Cu+1 & Cu+2). Copper is not typically found in city tap water. The major source of Copper in drinking water is corrosion of household pipes, fixtures, and faucets. Blue-green stains on plumbing fixtures, sinks, and bath tubs may indicate Copper is present.  If Copper is detected in older plumbing, a test for Lead should also be conducted. USEPA limit for Copper is 1.3 ppm.